Drop Seat Kit With Unpainted Special Side Covers With Special Chrome Rear Saddlebag Guards 09-13 And Used Without OEM Saddlebag Side Rails

Bagger Werx 3.0” Drop Seat Frame Rail Kits for Harley-Davidson Touring Models

NOTE: PLEASE CONTACT US AT 1-408-623-0050 FOR ADD ONS TO ANY DROP SEAT KIT ORDER

• Fits Harley Touring / Dresser / Bagger models 2009 thru 2013
• Dropping the seat rail height a full 3.0 inches on Touring models without changing the bikes stock ride height and ground clearance
• Get the slammed look that you are after without sacrificing the handling andclearance of lowering kits.
• Fender, fender struts and saddlebags remain at the stock height and location, onlythe set area drops down. Note: All Harley accessories attachable and detachable fitin stock location.
• This is a total bolt on kit, no welding or cutting involved
• Rear section is pre-assembled ready to bolt on to save you time & money.
• The kit installs in appox. 3 to 4 hours for either Non ABS and ABS brake models
• ABS models do not require brake lines to be disconnected and the ABS system tobe bleed and re-set.
• Kit eliminates the O.E.M. saddlebag guards & rails. Note: On models equipped with
• Harley O.E.M. rear saddlebag guards & rails that are no longer used, optional saddlebagguard kits are available through Bagger Werx. Please see the following part numbers forcomplete Drop Seat Kit with saddlebag guards. Part #’s 501043, 501044 and 501040.
• Kit includes: Gloss Black powder coated fully-assembled rear section, battery box,fuse box, negative battery cable, left & right side covers, a custom seat and allnecessary hardware & detailed instruction manual
• old as a Kit

Note: If you have a 2010 thru 2013 CVO STREET GLIDE FLHX or CVO ROAD GLIDE ULTRA FLTR
motorcycle, the Bagger Werx Drop Seat Kit should not be installed as it will cause the rear tire to rub on
the battery box which could lead to serious injury or death. These models are equipped with an 18”,
high profile rear tire. We do not recommend doing so but possibly using a low-profile 18” rear tire such
as Metzler or another brand rear tire may afford enough clearance to allow for installation of the Bagger
Werx Drop Seat Kit on these models. IMPORTANT: You should check the tire manufactures specifications
and your Harley Davidson service department recommendations before ordering and installing a low
profile tire on these models.

If you have a 2010 thru 2013 CVO STREET GLIDE FLHX or CVO ROAD GLIDE ULTRA FLTR equipped with
adjustable rear shocks it will be necessary to replace them with Harley Davidson air shocks part #54565-
09. This air shock has to be used to replace the FL CVO adjustable non-air shock when installing a Bagger
Werx drop seat kit, before installing the Bagger Werx Drop Seat Kit.

Bagger Werx highly recommends that the Bagger Werx Drop Seat Kit be installed by a qualified
Harley-Davidson technician. Note: If there has been any changes from the O.E.M. stock rear wheel , tire
or shocks it is the responsibility of the installer to check all clearances when installing the Bagger Werx
Drop Seat Kit (DSK).